Putting Up Drip Edge On Trim Siding Attaching

Install these fragile starter strips with a 15 gauge.

Putting up drip edge on trim siding attaching.

Using drip edge with a nailing edge approx. Apply a continuous bead of cement along the top of the drip edge then press down on the shingle. If necessary secure the ends of the drip edge with short roofing nails. Snap a line 1 in.

T shape drip edge is an l shaped flashing in which the long leg folds back on itself before heading down. Start by making an outline on the siding where you want to position the ledger board. Lift the shingles slide the drip edge underneath them and position it so that it extends over the gutters then replace the shingles and push down to seat the drip edge. Secure the drip edge with roofing cement.

Some drip edge flashings actually help houses turn to mush. Coat the flat part of the flashing that sits on the deck using a putty knife. Just be sure they re positioned high up under the shingles. To provide a common reference point measure up 8 in.

Above the bottom of the wall sheathing as a guide. Create a drip edge. From the top of this row and stretch a string line across the deck. Snap a chalk line cut out the siding and tack up the ledger board.

If it doesn t pull the drip edge out slightly from under the shingles. Drip edge roof flashing types. Turns out not all drip edge flashing perform the same. The common practice of installing drip edge tightly to the fascia creates a path for water to cling to the fascia and run down it wearing the face of the fascia and shortening its lifespan.

Begin by installing the first row of siding on both sides of the deck. These strips installed at the bottom will make your first row of siding angle out to match the rest of the rows. Nail the trim every 12 inches on center. Apply roofing cement when installing drip edge on an existing roof.

Find your most beat up pieces of siding and rip them down into 1 1 4 in. Make the outline large enough to include space for the deck boards on. Nail the side pieces every 12 inches placing the top nail at the top of the nailing slot and all other nails in the center of the nailing slot. L shape drip edge is a simple 90 degree bend with a flare out at the bottom of the short leg.

Then slip flashing behind the siding covering the top edge of the ledger.